First Time Setup; Setting The Clock With The Accuclock Function - Onkyo CR-535 Instruction Manual

First Time Setup

Setting the Clock with the AccuClock Function

To use the AccuClock function, the CD receiver must be able to receive RDS radio stations, which means an FM antenna
must be connected. Be sure to connect an FM antenna before attempting to use this function (see page 16).
The very first time you turn on the CD receiver, the AccuClock function automatically sets the CD receiver's clock based
on the CT (Clock Time) information present in an RDS radio broadcast. While the clock is being set, "Wait..." flashes
on the display, as shown. Note that it may take up to 5 minutes to set the clock.
When the clock has been set, the message "Clock Adjusted" scrolls across the display, then the day and time are dis-
played for a while, as shown.
The AccuClock function automatically updates the clock daily at 2 A.M., 3 A.M., and 2 P.M.
If for some reason the clock cannot be set automatically, see "Setting AccuClock to Use a Specific Station" on page 48
and "Setting the Clock Manually" on page 49.
Turning Off the AccuClock Function
If you don't want AccuClock to automatically update the clock each day, you can turn it off as follows.
TIMER
1
2
YES/MODE
ENTER
3
Note:
The AccuClock function cannot be turned off until the
clock has been set.
Press the [TIMER] button repeat-
edly until "Clock" appears on the
display.
Press [ENTER].
"*AccuClock*" appears on the display.
The asterisks indicate that the
AccuClock function is on.
To turn off AccuClock, press the
[YES/MODE] button.
The asterisks disappear, indicating that
the AccuClock function is off. To turn
AccuClock back on again, press the
[YES/MODE] button so that the aster-
isks are displayed.
23