Connecting An Onkyo Md Recorder - Onkyo CR-535 Instruction Manual

Connecting Other Components—Continued

Connecting an Onkyo MD recorder

The following diagram shows how to connect an optional Onkyo MD recorder.
Connect the CD receiver's MD/TAPE OUT jacks to the MD recorder's INPUT (REC) jacks, and connect the CD
receiver's MD/TAPE IN jacks to the MD recorder's OUTPUT (PLAY) jacks.
CD receiver's
rear panel
: Signal flow
What can you do with
• Connecting an Onkyo MD recorder to the CD receiver with an
the CD receiver's remote controller. In addition, when playback is started on the MD recorder, the CD receiver will
automatically select it as the input source.
• To use , you must connect the Onkyo MD recorder to the CD receiver with an
(RCA). In addition, the Input Display for the MD/TAPE jacks must be set to "MD" (see page 26).
• Some -capable components have two
is for connecting additional
Notes:
• When listening to the audio of a component connected to the CD receiver but with no
input source.
• It is also possible to connect the MD/TAPE jacks to a DAT recorder. When connected to a DAT recorder, set the Input
Display to "DAT" (see page 26).
• The MD/TAPE IN jacks can be connected to the audio output jack of a VCR. The VCR video output jack should be
connected to a TV. When the CD receiver is connected to a VCR, set the Input Display to "VIDEO" (see page 26).
Red
White
Analog audio cables (RCA)
White
Red
cable supplied with
the Onkyo MD recorder
?
jacks. They're both the same, so you can use either one. The extra jack
-capable components.
Onkyo MD recorder's
rear panel
INPUT OUTPUT
(REC) (PLAY)
L
R
White Red Red White
cable allows you to control the MD recorder with
cable and an analog audio cable
connection, select TAPE
REMOTE
CONTROL
21