Aiphone GT SYSTEM Installation Manual page 22

Screws
3-8 Door station
For door stations other than the GT-D, see the included instructions.
Mounting frame
Mounting
screws ×2
Do not block the
drainage hole.
Chassis
1-gang box
83.5 mm (3-5/16")
OR
60 mm (2-3/8")
Round back box
Terminal block
Mounting bracket
1-gang box
Mounting screw
83.5 mm (3-5/16")
OR
60 mm (2-3/8")
Screws
Round back box
Place " UP" upwards.
83.5 mm (3-5/16")
1-gang box
1
Mount the station unit to the chassis or mounting bracket.
2
Connect the wiring to the terminal block.
GT-1M-L:
• To remove the terminal block, slide the terminal block and pull it out.
• Strip away the jacket of the cable and insert all wires into the slots in an orderly
fashion. Failure to do so could result in pinching that may damage the wiring.
3
Mount the station unit to the chassis or mounting bracket.
• For surface wiring, cut out the cable inlet.
1
Loosen the screws and remove the mounting frame and main unit.
2
After connecting the wiring, mount the main unit to the mounting
frame.
• For surface wiring, insert wiring from the cable inlet (lower part).
- 22 -