Aiphone GT SYSTEM Installation Manual page 17

6
Remove the terminal cover.
7
From the speech module to the next module, insert the attached connector into the
socket.
Make sure to run the cable under the terminal cover for protection.
8
Connect the connectors between the modules with cables.
Mount modules on the back boxes.
Example of interconnection of modules
9
Run the connection cable through the joint pipe (which you should have made open in
advance) and connect CN1 of the GT-SW to the next row.
10
Put back the terminal cover.
Mount the front frame and tighten with the special screwdriver (enclosed with GT-
BC).
11
For the GT-SW and GT-AD, remove the resident name/address plate or paper by
pressing either the left or right end. (Peel off the plastic film.)
Use a permanent pen to write the resident name and address on the transparent plate
and mount the plate on the module.
- 17 -
Use the GF-C to connect to the name scrolling module.
To position the speech module in the center row, run the
GF-C through the joint pipe in advance.