Additional Measurement Functions - Agilent Technologies E1326B User Manual

Additional Measurement Functions

Additional Stand-Alone
Multimeter Functions
Additional Scanning
Multimeter Functions
Chapter 3
The following MEASure
the example programs to make measurements other than DC voltage.
The following statements can be substituted into the program "Making a
Single Measurement" on page 42.
! AC voltage.
OUTPUT 70903;"MEAS:VOLT:AC?"
! 4-wire resistance.
OUTPUT 70903;"MEAS:FRES?"
! 4-wire thermistor (type = 2252, 5000, 10000).
OUTPUT 70903;"MEAS:TEMP? FTH,type"
! 4-wire RTD (type = 85, 92).
OUTPUT 70903;"MEAS:TEMP? FRTD,type"
The following statements can be substituted into the programs where the
faceplate terminals are used to make multiple reading bursts or multiple
burst measurements.
! AC voltage.
OUTPUT 70903;"CONF:VOLT:AC"
! 4-wire resistance.
OUTPUT 70903;"CONF:FRES"
! 4-wire thermistor (type = 2252, 5000, 10000).
OUTPUT 70903;"CONF:TEMP FTH,type"
! 4-wire RTD (type = 85, 92).
OUTPUT 70903;"CONF:TEMP FRTD,type"
The following statements can be substituted into the program "Scanning a
Channel List" on page 46.
! AC voltage.
OUTPUT 70903;"MEAS:VOLT:AC? (@channel_list)"
! 2-wire resistance.
OUTPUT 70903;"MEAS:RES? (@channel_list)"
! 4-wire resistance (channels available are 00 through 07).
OUTPUT 70903;"MEAS:FRES? (@channel_list)"
! Thermocouple (type = B, E, J, K, N14, N28, R, S, T).
OUTPUT 70903;"MEAS:TEMP? TC,type,(@channel_list)"
Using the HP E1326B/E1411B Multimeter
and CONFigure statements can be substituted into
69