Using The Fl Ash; Adjusting The Brightness (Exposure Compensation) - Olympus Stylus 1050SW Basic Manual

2
Use 34 to select [ON], and press
the o button to set.
3
Point the camera toward the
subject. Check the frame appearing
around the face detected by the
camera, and then press the shutter
button to take the picture.
For some subjects, the frame may not
appear or may take some time to appear.
When set to [ON], [ESP/n] (p. 30) is
automatically fi xed to [ESP], and [AF
MODE] (p. 31) is automatically fi xed to
[FACE DETECT].
Using the fl ash
The fl ash functions can be selected to best
match the shooting conditions and render the
desired image.
1
Press the # button.
You can operate the camera by tapping the
body when [TAP CONTROL] is [ON].
[TAP CONTROL] (p. 48)
P
AUTO
SET SET OK OK
FLASH AUTO FLASH AUTO
! $
AUTO #
2
Use 34 to select the setting option,
and press the o button to set.
Item
The fl ash fi res automatically in
FLASH AUTO
low-light or backlight conditions.
This emits pre-fl ashes to reduce
REDEYE the occurrence of red eye in your
photos.
The fl ash fi res regardless of the
FILL IN
available light.
FLASH OFF The fl ash does not fi re.
Adjusting the brightness
(Exposure compensation)
The standard brightness (appropriate exposure)
can be adjusted brighter or darker to obtain the
desired shot.
1
Press the F button.
EXPOSURE COMP.
Exposure compensation value
2
Use 1234 to select the desired
brightness image, and press the
o button.
Description
0.0 0.0 +0.3 +0.3
+0.7 +0.7 +1.0 +1.0
EN 13