To Set Limits Of Measurements - HP 53131A Operating Manual

Chapter 1 Getting Started
Making Measurements

To Set Limits of Measurements

To demonstrate how Math and Limits work together, use the Scale (10)
and Offset (1 Mega) values selected in the previous procedure "To Select
Scale and Offset." Enable Math by performing the following steps.
Scale &
Offset
Run
The result of this Math operation is a measurement of 101 MHz.
(Measurement Scale) + Offset = Result
(10 MHz 10) + 1Mega = 101 Mega
Now, set the upper limit to 102 Mega and the lower limit to 100 Mega by
performing the following procedures. (Figure 1-1 and Figure 1-2 illustrate
the limits settings.)
Operating Guide
Display 1, 7/13/92
Display 1, 7/13/92
Freq Ch 2
M
1-23