Setting The Parity; Setting The Software Pace - HP 53131A Operating Manual

Chapter 2 Operating Your Universal Counter
Using the Utility Menu

Setting the Parity

You can select the parity for RS-232 operation. The Counter is configured
for parity off when shipped from the factory.
1 Press Recall (Utility) key until PARITY: is displayed.
2 Press any one of the arrow keys until the desired parity is displayed.
The parity choice is stored in non-volatile memory, and does not change
when power has been off or after a remote interface reset.

Setting the Software Pace

You can select the software pace for RS-232 operation.
1 Press Recall (Utility) key until SW PACE: is displayed.
2 Press any one of the arrow keys until the desired software pacing is
displayed.
The software pacing choice is stored in non-volatile memory, and does not
change when power has been off or after a remote interface reset.
Operating Guide 2-63