Entering The Offset Value - HP 53131A Operating Manual

NOTE
Chapter 1 Getting Started
Making Measurements

Entering the Offset Value

To demonstrate the Offset Math operation, set the Offset to 1 MHz as
shown in the following steps.
Scale &
Offset
At this point, pressing the
display of the Offset value as shown in the following step.
Press the key six more times to cause the Counter to display your entry
in Mega units as shown in the following step.
The leftmost "0" digit in the OFFSet display is highlighted, indicating that
if you press key once the displayed value will increase to 1 Mega
(that is, 1E6) as shown in the following step.
Enter
BE SURE to press the Enter key to enter the 1 Mega value.
The Offset is now set to 1 Mega.
Operating Guide
key will cause the Counter to display the full
M
M
M
1-21