Burner - Miele CS 1012 Operating And Installation Instructions

Cleaning and care

Burner

Do not clean any parts of the burner
in a dishwasher.
The burner should be dismantled and
then cleaned by hand using a solution
of warm water and a little washing-up
liquid applied with a soft sponge.
Parts of the burner that cannot be
removed should be wiped clean with a
damp cloth only.
The ignitor and ignition safety device
should be very carefully wiped clean
using a well wrung out cloth.
Do not let the ignitor get wet. If it gets
wet it will not spark.
After cleaning dry all surfaces with a
clean cloth.
Make sure that the flame slits are clean
and completely dry.
The surface of the burner cap will
become more matt with time. This is
quite normal and will not affect the
operation of the hob.
24
Reassemble the burner
After cleaning the burner it must be
reassembled in the correct order.
^ Place the burner head o on to the
burner base r so that the ignition
safety device p and the ignitor q
extend through their respective holes
in the burner head. The burner head
must click into place correctly.
^ Place burner cap n flat over burner
head o.
When correctly positioned it will not
slide about.