To Confirm The Filter Has Been Changed - Miele F 1811 Vi Operating And Installation Manual

Water filter
To confirm the filter has been
changed
The reminder to change the filter
continues to flash.
^ Touch the access sensor so that it is
highlighted in yellow.
^ Take note of the position of the X
sensor (but do not touch it!).
^ Touch the access sensor until it is
highlighted in white and all of the
other sensors are no longer lit up.
^ Place your finger in the position of the
X sensor, and leave it there.
^ At the same time, briefly touch the
access sensor (without moving your
finger from the X sensor).
^ Leave your finger on the X sensor for
another 4 seconds until the
Y sensors also appear in the display.
^ Now touch the X sensor repeatedly
until ^ appears in the display.
44
^ Touch the access sensor again.
^ By touching the X sensor you can
now select:
^ 0: The water filter is fitted
^ 1: The reminder to change the
^ 2: To confirm the filter has been
^ –: Return to menu
^ Touch the X sensor repeatedly until
^ 2 appears in the display.
The ^ 1 function should only be
selected if the household water
supply is already fitted with a water
filter. If this is the case, use the stan-
dard water filter in your appliance.
^ Now touch the access sensor for 2
seconds to confirm that the filter has
been changed.
This activates the reminder for the next
filter to be changed.
^ Touch the X sensor repeatedly until
^ – appears in the display.
;
and the
^ Touch the access sensor.
^ Touch the X sensor repeatedly until ;
appears in the display.
^ Touch the access sensor.
You have now left settings mode.
The reminder to change the filter will
now go out in the display.
^ Close the appliance door.
filter is deactivated
(standard setting)
changed