Problem Solving Guide - Miele H 348 B2 Operating Instructions Manual

Problem solving guide

Installation, maintenance and repairs
to the electrical components of this
appliance should only be carried out
by a suitably qualified and competent
competent person in accordance
with national and local safety
regulations. Repairs and other work
by unqualified persons could be
dangerous. The manufacturer cannot
be held liable for unauthorised work.
Ensure current is not supplied to the
appliance until after maintenance or
repair work has been carried out.
Some minor problems can be corrected
without contacting the Miele Service Dept.
What to do if . . .
. . . the oven does not heat up.
Check whether,
^ the selector switch is set to the function
required, and the temperature control
is set at the correct temperature.
^ the operating lock is activated
(bottom oven).
^ the mains fuse has tripped. Contact a
qualified electrician or the Miele Ser-
vice Department.
. . . "12:00" flashes in the timer display.
This is not a fault.
There has been an interruption to the
power supply. After a power cut
– the time of day has to be entered again,
– the operating lock has to be
reactivated.
48
. . . the heating works, but not the
oven lighting.
Make sure the halogen lamp is
connected properly in its socket.
If after checking it, it still does not work
you will need to change it:
^ Disconnect the appliance from the
electricity supply: Switch off at the
isolator or the mains fuse box.
^ Remove the runners.
^ Lift the lamp cover from its retainers.
^ Replace the halogen lamp:
12 V, 20 W, heat resistant up to 300°C,
G4 socket, Osram, Type 64428.
Exercise caution when changing a
lamp. Halogen lamps get very hot
during use and will remain hot for some
time after being switched off.
Do not touch the surface directly when
changing the lamp as grease particles
from your fingers will adhere to the
surface and damage it. Please follow
the manufacturer's instructions.
Reassemble in the reverse order, carefully
ensuring all parts are correctly in place.
^ Press the lamp cover back in its
retainers and put the runners back.