Setting Margin Defaults; Erasing Borders; Selecting Maximum Number Of Copies - Triumph Adler DCC 2520 Instruction Handbook Manual

System Menu
4
Press [Close] to save settings or [Back] to cancel settings. The display returns to the Copy Default
screen.

Setting Margin Defaults

Set margin the width default values. The setting ranges are as follows.
Model Type
Inch models
Metric models
For further details about margin mode, refer to page 1-17.
1 Referring to Accessing the Copy Default screen on page 7-2, access the Copy Default screen.
2
Press [ ] or [ ] to select Default margin width and press [Change #].
3
Press [ ], [ ], [ ] or [ ] to set the margin width.
4 Press [Close] to save settings or [Back] to cancel settings. The display returns to the Copy Default
screen.

Erasing Borders

Set the border erase default values. The setting ranges are as follows.
Model Type
Inch models
Metric models
For further details about border erase, refer to page 1-19.
1 Referring to Accessing the Copy Default screen on page 7-2, access the Copy Default screen.
2
Press [ ] or [ ] to select Default erase width and press [Change #].
3 Press [+] or [–] to set the Border (outer edges) and Center (Centre) (middle) border widths.
4 Press [Close] to save settings or [Back] to cancel settings. The display returns to the Copy Default
screen.

Selecting Maximum Number of Copies

Limits the number of sets that can be specified for a single copy. Set to between 1 - 999 sets.
1
Referring to Accessing the Copy Default screen on page 7-2, access the Copy Default screen.
2 Press [ ] or [ ] to select Preset limit and press [Change #].
3 Use the numeric keys to specify the preset limit value.
4
Press [Close] to save settings or [Back] to cancel settings. The display returns to the Copy Default
screen.
7-10
Range
-
0 3/4" (1/8" increments)
0 - 18 mm (1 mm increments)
Range
-
0 2" (1/8" increments)
0 - 50 mm (1 mm increments)