Document Errata; Installing Mass Storage Drivers During Setup; Installing The Adaptec Scsi Controller Driver - Intergraph InterServe 80 Manual

Document Errata

In the System Setup document:
u
In Chapter 2, "Setting Up the Software," the location of the online System Introduction
document may be incorrect. The correct location is
u
In Chapter 4, "Operating Notes," the locations of the system's serial number and model
number have changed. Both are on a label under the the top cover at the front of the
chassis. The serial number is also found on a bar-code label on the back panel.
In the System Reference document, references to Chassis Fan 1 and Chassis Fan 2 (and their
system board connectors) are reversed. Chassis Fan 1 is the bottom front fan; Chassis Fan 2 is
the top rear fan. The system board connector for Chassis Fan 1 is J54; the system board
connector for Chassis Fan 2 is J5.
Windows NT 4.0

Installing Mass Storage Drivers During Setup

The System Setup document delivered with the system contains instructions for reinstalling the
operating system if needed. The instructions for what to do during installation of the
operating system direct you to bypass automatic detection of mass storage devices during
Setup. This is incorrect; instead of bypassing automatic detection, you should do the
following:
u
When prompted during Setup, select automatic detection of mass storage devices.
u
After completing Setup, reinstall the driver for the SCSI controller (SYMSCSIDRV) from
backup diskette.
For instructions on creating backup diskettes containing system software, see the System Setup
document and InterSite Version Manager Help. For instructions on installing a driver from
diskette, see the

Installing the Adaptec SCSI Controller Driver

If you have to reinstall Windows NT 4.0 on a system with an optional Adaptec SCSI
controller, be sure to reinstall the driver for the SCSI controller (2940
diskette during Setup.
To install the 2940
1. When prompted, press
. file on the backup diskette containing the driver software.
README TXT
driver during Setup:
SCSIDRV
to bypass detection of mass storage devices.
S
:\ 32 \ .
C WIN APP SYSINTRO
) from backup
SCSIDRV
5