ZyXEL Communications Prestige 623R-T User Manual page 61

LABEL
Sustain Cell Rate The Sustain Cell Rate (SCR) sets the average cell rate (long-term) that can be
Maximum Burst Size Maximum Burst Size (MBS) refers to the maximum number of cells that can be sent at
Login Information
Service Name (PPPoE only) Type the name of your PPPoE service here.
User Name Enter the user name exactly as your ISP assigned. If assigned a name in the form
Password Enter the password associated with the user name above.
IP Address
IP Address Enter the static IP address provided.
Subnet Mask Enter a subnet mask in dotted decimal notation.
WAN Setup
Table 5-1 WAN Setup
transmitted. Type the SCR, which must be less than the PCR.
the peak rate. Type the MBS, which is less than 65535.
(PPPoA and PPPoE encapsulation only)
user@domain where domain identifies a service name, then enter both components
exactly as given.
This option is available if you select Routing in the Mode field.
A static IP address is a fixed IP. A dynamic IP address is not fixed; the ISP assigns you
a different one each time you connect to the Internet.
Select Obtain an IP Address Automatically if you have a dynamic IP address. This
option is not available for remote node setup.
Select Static IP Address and set the fields below.
For remote node setup, enter the IP address in the same subnet
Refer to the Subnetting appendix in the to calculate a subnet mask If you are
implementing subnetting.
For remote node setup, enter the remote node's subnet mask.
Prestige 623R-T ADSL Dual-link Router
DESCRIPTION
as the remote node.
5-5