Table of Contents
Advertisement
Thermal Conductivity Analyzer
4.1
Although the Model 2020 is usually programmed to your application at
the factory, it can be further configured at the operator level, or even,
cautiously, reprogrammed. Depending on the specifics of the application,
this might include all or a subset of the following procedures:
•
•
•
•
Before you configure your 2020, the following default values are in
effect: RANGE/APPLICATIONS: refer to data sheet on the first page of
this manual;
Range:
Alarm Relays:
Zero:
Operation
Introduction
Setting system parameters:
•
Establish a security password, if desired, requiring Operator
to log in.
•
Establish and start an automatic calibration cycle, if desired.
Routine Operation:
•
Calibrate the instrument.
•
Choose autoranging or select a fixed range of analysis.
•
Set alarm setpoints, and modes of alarm operation (latching,
fail-safe, etc).
Program/Reprogram the analyzer:
•
Define new applications.
•
Linearize your ranges.
Special functions setup:
•
Set output reversal.
•
Set polarity reversal or offset output.S
•
Set gain amplification.
Manual
Defeated, 0.00%, HI, NOT Fail/Safe, not latching
Auto, every 0 days 0 hours
Teledyne Analytical Instruments
Operation 4
4-1
Advertisement
Table of Contents
