5725A
Instruction Manual
DRESS CABLES
AS SHOWN
6-11. Accessing the High Voltage Amplifier (A3)
The High Voltage Amplifier assembly lays flat on the top of the instrument, toward the
front. To access the High Voltage Amplifier assembly, simply do the Initial Access
Procedure. This leaves the assembly in the service position.
When reinstalling the assembly, lower it into place squarely to make sure
its connector seats correctly in the Interconnect assembly connector.
6-12
CURRENT
AMPLIFIER
(A2)
BRIDGE
RECTIFIER
HEAT SINK
Figure 6-6. Correct Way to Dress Cables
Note
aq18f.eps