Fluke 45 User Manual page 69

45
Users Manual
In the following examples, <space> between commands is for readability only. However a
<space> between a command and its argument is required. The PRINT command sends a
terminator at the end of the string.
EXAMPLE 1:
IEEE-488 bus address
Reset to power-up configuration
Select
EXAMPLE 2:
IEEE-488 bus address
Reset to power-up configuration
Select volts ac function
for primary display
5-10
The following string configures the meter and triggers an ohms reading to be shown
on the primary display.
PRINT @3,
W function
Select 300 W range
Select medium reading rate
Select external trigger
(Rear panel trigger disabled, no trigger delay)
Trigger a reading
Return reading shown on primary display
The following string configures the meter and triggers a volts ac reading in primary
display and a frequency reading in the secondary display.
PRINT @3,
Select frequency
for secondary display
Select 300V range for primary display
Select external trigger
(Rear panel trigger disabled, no trigger delay)
Trigger a reading
Return reading shown on primary display
Figure 5-1. Typical IEEE-488 Input Strings
"*RST; OHMS; RANGE 1; RATE M; TRIGGER 2; *TRG;
"*RST; VAC; FREQ 2; RANGE 4; TRIGGER 2; *TRG;
VAL1?"
VAL1?"
aam19f.eps