Preparing The Meter To Be Operated Via Ieee-488 Interface; Ieee-488 Operating Limitations; Installing The Ieee-488 Interface; Enabling The Ieee-488 Interface - Fluke 45 User Manual

Preparing the Meter to be Operated via IEEE-488 Interface

To turn the meter into a fully programmable element of an automated testing system, use
the IEEE-488 Interface option, as described below.

IEEE-488 Operating Limitations

The following limitations govern the IEEE-488 interface:
A maximum of 15 devices can be connected in a single IEEE-488 bus system.
The maximum length of IEEE-488 cable used in one IEEE-488 system must be the
lesser of 20 meters or 2 meters times the number of devices in the system.

Installing the IEEE-488 Interface

If the meter was not shipped with the IEEE-488 option installed, install the IEEE-488
interface according to the instructions provided with it.
To determine if the IEEE-488 interface is installed, perform the procedure under "Enabling
the IEEE-488 Interface" (below). "IEEE" is displayed only if the IEEE-488 interface is
installed in the meter.

Enabling the IEEE-488 Interface

The IEEE-488 interface can only be enabled from the front panel. Perform the following
procedure to enable the IEEE-488 interface:
1. Press in the POWER button on the front panel to turn the meter on.
2. Press , then press
The baud rate currently selected is shown in the primary display and "baud" in the
secondary display.
3. Press the
232 capability is now disabled.
"IEEE" can only be selected if the IEEE-488 interface board has been
installed and the meter is connected to line power. If the meter is under bat-
tery power and you attempt to select "IEEE" the N flashes and "IEEE"
cannot be selected until the meter is connected to line power.

Addressing the Meter

After the IEEE-488 interface board has been installed and enabled, the meter must be
assigned an address between "0" and "30".
Perform the following procedure to assign the meter a valid address:
1. Press in POWER to turn the meter on.
2. Press , then press
3. Press or
The address will remain selected until it is changed.
4. To exit and return the meter to normal operation without changing the address, press any
button but
Preparing the Meter to be Operated via IEEE-488 Interface
.
to scroll to "IEEE"; then press
Note
(ADDR).
to scroll to the desired address. Then press
, , or .
Operating the Meter Using the Computer Interface
to enable the IEEE-488 interface. RS-
to select that address.
5
5-5