Using The Number Editor - Fluke 45 User Manual

Dual display multimeter
Hide thumbs Also See for 45:
Table of Contents

Advertisement

45
Users Manual
To Set
Touch Hold Minimum
Response Level
Decibel Reference
Impedance in Ohms
RS-232 Baud Rate
IEEE-488 Address(If
IEEE-488 Interface
Installed and selected.)
RS-232 PrintOnly
Mode (If RS-232
Interface Selected)
Trigger Type
3. When you have scrolled to 16, press
becomes bright, indicating that it is the selected value.
This dB reference will remain selected until you change it (as described above), turn the
meter off, or reset the meter to the power-up configuration by pressing and holding down

Using the Number Editor

Use the number editor to set the relative base, or the low (LO) and high (HI) points for
compare (COMP) operations (see "Using the Compare Function" earlier in Chapter 3).
To use the number editor, proceed as follows:
1. To invoke the desired number editor, press
3-18
Table 3-11. Options Available Through List Editor
Pushbuttons
then
(THRESH)
then
(REF
)
then
(BAUD)
Parity options list
displayed
Echo Mode
then
(ADDR)
then
(ADDR)
and
simultaneously
during power-up. (See "Changing the Power-Up Configuration" later in Chapter 3.)
#). See Table 3-12
Table 3-12. Number Editor Options
Pushbuttons
then
(LO)
then
(Hi)
then
(REF #)
Options
"1" (5 % of range);
"2" (7 % of range); or
2, 4,8,16,50,75,93,
110,124,125,135,150,
250, 300,500,600, 800,
900,1000,1200, or 8000
300,600,1200,2400,
4800, or 9600
"E" (even), "O" (odd),
"no" (none)
On or Off
Valid addresses between
0-30
1,2,5,10,20,50,100, 200,
500,1000,2000,
5000,10000,20000, or
50000
1,2,3,4, 5 (See Table 5-
14.)
to set the dB reference impedance. "16" now
then press
Number Editor Invoked On
Low Point for Compare Mode
High Point for Compare Mode
Relative Base
Annunciator
"HOLD"
"3" (8% of range)
"dB" and " ";
also "V" when
1000
"baud"
"PAR" for parity
"Echo" and "On"
or "OFF"
"IEEE"
"PRINT"
"tri"
,
, or
(REF

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents