Yamaha PM1D Supplementary Manual page 39

If surround mode = 6.1ch
7
7 DIVERGENCE
These parameters specify the balance (0–100) at
which a signal panned to the center will be sent to the
center buses (C, S, Bs) and the left/right buses (L, R,
Ls, Rs). With a setting of 0, the signal will be sent
only to the left/right buses. With a setting of 100, the
signal will be sent only to the center buses. With a
setting of 50, the same level will be sent to the left/
right buses and the center buses.
If 6.1ch is selected as the surround mode, the screen
will show an F knob that adjusts the front divergence,
an R knob that adjusts the rear divergence, and a
LINK button between them.
The LINK button links the front and rear divergence.
If you switch this button on, the value of the F knob
will be copied to the R knob, and the F knob and R
knob values will be linked.
If 3-1ch or 5.1ch are selected as the surround mode,
the screen will show only a knob that adjusts the
front divergence.
If surround mode = 3-1ch or 5.1ch
8
8 LFE (Low Frequency Effects) knob
Adjusts the output level of the signal sent from the
input channel to the LFE (Low Frequency Effects)
bus for the subwoofer. The signal sent from the input
channel to the LFE bus can be switched on/off by the
ON/OFF button.
This knob and button will appear only if the sur-
round mode is 5.1ch or 6.1ch.
9
0
A
9 Surround pan grid
Adjusts the surround panning centered on the listen-
ing point. The current position is shown by the
symbol.
0 Panning buttons
These buttons correspond to the surround buses. If
you move the cursor to a button and press the
[ENTER] switch, the panning will move to that posi-
tion.
A Surround bus ON/OFF buttons
The signal sent from the input channel to each sur-
round bus can be switched on/off using these but-
tons.
Surround panning
39