Using The Global Channel Copy Function - Yamaha PM1D Supplementary Manual

1 SEL (select the copy-source channel)
Selects the copy-source channel. The procedure is the
same as for the identically-named button in CH
VIEW.
2 Channel number/name
Displays the number and short name (or unit name)
of the copy-source channel.
3 Pair setting
Indicates the pairing status of the channel that is
selected as the copy-source. You can also click this
button to enable/disable pairing.

Using the Global Channel Copy function

1. Access the CH COPY screen of the IN CH VIEW or
OUT CH VIEW function.
2. Press a [SEL] switch to select the desired copy-
source input channel or output channel.
Alternatively, you can select the copy-source by click-
ing a SEL button in the screen to access the CHAN-
NEL SELECT popup window.
If you change the copy-source, all settings in the
PARAMETER SELECT area and the DESTINA-
TION CH SELECT area will be cancelled.
3. Use the buttons in the PARAMETER SELECT area
to select the parameters that you want to copy.
The following parameters can be selected.
IN CH VIEW function CH COPY screen
ALL.................. All parameters except for NAME
ATT ................. Attenuator
EQ ................... EQ function settings
GATE............... GATE function settings
COMP............. COMP function settings
DELAY ............ DELAY function settings
FADER ............ Fader level
4 WITHOUT MIX SEND/WITH MIX SEND button
(only in the OUT CH VIEW function CH COPY
screen)
When a MIX channel is selected as the copy-source,
this button selects whether the send levels of the sig-
nals sent from each input channel to that MIX bus
will be copied. These two buttons are valid only if the
PARAMETER SELECT: ALL button is on.
5 PARAMETER SELECT
Selects the parameter to be copied.
6 DESTINATION CH SELECT (select the copy-desti-
nation channels)
Selects the copy-destination channels. Buttons corre-
sponding to the copy-source channel and buttons for
channels of types differing from the copy-source
channel will be grayed-out, and cannot be selected.
ON ...................[ON] switch on/off status
PAN/BAL.........Pan/balance setting
INSERT ...........Insert on/off and insert position
SEND...............Send level to the specified MIX
bus(es)
DCA.................DCA groups to which the channel
belongs
MUTE..............Mute groups to which the channel
belongs
LCR..................Settings of the LCR screen
NAME..............Name of the input channel
Hint
If the SEND button is on, use the MIX area at the
right to select the send-destination MIX bus(es).
(You may select more than one.)
If you click the ALL button, all parameters except
for NAME will be selected. At this time, all MIX
buses will be selected for the SEND parameter.
Global Channel Copy
25