About The Version Checking Function - Yamaha PM1D v.2 Installation Manual

• Internet Explorer 4.0 or later
• Display capability of 800 x 600 pixels (SVGA, High Color) or
better
• 10 MB or more free hard disk space
• Mouse
• CD-ROM drive
• Serial port
• RS-232C cable (cross-connected)
• One ATA-compliant PCMCIA Type II PC Flash Storage card
(subsequently referred to as "memory card")
• A device with a PCMCIA Type II card slot (A system that
allows the files from the CD-ROM to be copied to the
memory card)

About the version checking function

The CS1D screen software contains a function that checks
whether the software of all components is a valid combination of
versions. If there is a combination of different versions, or if any
component has malfunctioned, the VERSION CHECK popup
window will appear when the CS1D starts up. This will not
appear if all components are correct. This version check function
is explained below.
1
3
4
5
A
Checking result message field
B
OK button (may not be displayed in some cases)
C
PM1D SYSTEM SOFTWARE version display field
D
CS1D screen software version display field
E
CS1D firmware version display field
F
ENGINE A DSP1D(-EX) firmware version display field
G
ENGINE A INPUT UNIT firmware version display field
H
ENGINE A OUTPUT UNIT firmware version display field
I
ENGINE B DSP1D(-EX) firmware version display field
J
ENGINE B INPUT UNIT firmware version display field
K
ENGINE B OUTPUT UNIT firmware version display field
6 7
9
J
PM1D V2 System Software Installation Guide
Version display fields
information.
L
Component name or firmware name
M
Firmware version display field for
N
Result of test
Of these fields, lines displayed in white characters indicate
the version of that entire component. Lines displayed in
smaller characters of gray provide details on firmware
versions of individual CPUs within the component. Of these,
M
fields and
M
• Field
x.xx
(numeric)
NO REPLY
2
--------
DIFF.
8
N
• Field
OK
----
K
NG
OLD
NEW
DIFF
The above test results are summarized, and a message is
shown in
following explanation and resolve the reason for the
problem.
[Results other than OK]
If there is a problem with other than the firmware that
operates the controls of the CS1D and the INPUT UNIT /
OUTPUT UNIT, the OK button
In this case, it will be impossible to perform any screen
operations or use any of the controls, and thus impossible to
control the system.
Since correct operation cannot be guaranteed in such a state,
please remove the cause of the problem. The system will not
recover until the cause is removed.
If there is a problem with the firmware that operates the
controls of the CS1D and the INPUT UNIT / OUTPUT UNIT,
the OK button
Click the OK button, and the system will forcibly be started up,
ignoring the faulty component or faulty portion of the
component.
At this time, a popup window will appear to inform you which
component is being ignored, and the following limitations will
apply. However, the correctly functioning components will
operate, allowing you to control the remaining portions of the
system.
4 K
through convey the following
L M
L
N
may be of the following types.
display list
Firmware version
CPU within the component does not respond
Board not installed in the DSP1D(-EX)
Board is incorrectly inserted in the DSP1D(-EX)
display list
Normal
Not connected (normal)
Illegal firmware version within the component or
no response from CPU within the component
Old version
New version
Illegal combination of versions
1
. If this popup window appears, refer to the
2
will not appear.
2
will appear.
N
3