A-1. 2640A/2645A General Specifications - Fluke NetDAQ 2640A User Manual

2640A/2645A NetDAQ
Users Manual
Specification
Channel Capacity
I/O Lines Total
Size
Weight
Power
Safety Standards
EMC Standards
Serial Interface (RS-232C)
Common Mode Voltage
A-2
Table A-1. 2640A/2645A General Specifications
Characteristic
20
12
9.3 cm high, 21.6 cm wide, 36.2 cm deep
(3.67 in high, 8.5 in wide, 14.28 in deep)
Net, 4 kg (8.8 lb.)
Shipping, 6.0 kg (13.2 lb.)
107 to 264V ac (no switching required), 50 and
60 Hz, 15VA maximum
9V dc to 16V dc, 6W maximum
If both sources are applied simultaneously, ac
voltage is used if it exceeds approximately 8
times the dc voltage.
Automatic switchover occurs between ac and
dc without interruption.
Both instruments comply with:
IEC 1010-1
UL 1244
CSA Bulletin 556B.
ANSI/ISA-S82.01-1994
CSA C22.2 No. 1010.1-92
When shielded cables are used, both
instruments comply with:
Vfg. 243/1991
FCC-15B, at the Class B level
EN 50081-1
EN 50082-1
Connector: 9 pin male (DI-9P)
Signals: TX, RX, DTR, RTS, GND
Modem Control: full duplex
Baud rates: 4800, 9600, 19200, 38400
Data format: 8 data bits, no parity bit, one stop
bit
Flow control: XON/XOFF
Echo: Off
2640A 150V (300V on channels 1 and 11)
2645A 50V dc or 30V ac rms.