Analog Audio Connection ([Input] & [Output] Connectors) - Yamaha DME8i-C Owner's Manual

Audio I/O Connection
Analog Audio Connection ([INPUT] & [OUTPUT] Connectors)
The DME Satellite can directly input and output audio signals via the [INPUT] and [OUTPUT] connectors.
Wire the supplied Euroblock plugs (3P) as shown below. You can use DME Designer to set the head amplifier
gain and turn the phantom power on and off for each [INPUT] connector.
Euroblock plug connection
Please be sure to use the supplied Euroblock plugs. If you lose them, contact your nearest Yamaha dealer.
NO T E
Use a slotted screwdriver with a blade width of about 3 millimeters to secure the cables to the
(3P) Euroblock plug.
Use a slotted screwdriver with a blade width of about 2 millimeters to secure the cables to the
(16P) Euroblock plug to connect to the [GPI] connector.
Cable preparation
• To prepare the cable for attachment to a Euroblock connector, strip the
wire as shown in the illustration, and use stranded wire to make
connections. With a Euroblock connection, the stranded wire may be
prone to breakage because of metal fatigue due to the weight of the
cable or due to vibration. When rack-mounting your equipment, use a
lacing bar when possible to bundle and fasten the cables.
• If cables will be frequently connected and disconnected, as in the case
of a portable installation, we recommend that you use ferrules with
insulation sleeves. Use a ferrule whose conductor portion has an
external diameter of 1.6 mm (1.3 mm for GPI) or less, and a length of
approximately 7 mm (5 mm for GPI) (such as the AI0,5-6WH made
by the Phoenix Contact corporation).
If you use stranded wire, do not tin (plate with solder) the exposed end.
CAUTION
1.
Loosen terminal screws.
2.
Insert cables.
3.
Securely tighten terminal screws.
Pull the cables (not too strongly) to confirm that they are
securely connected.
4.
Insert the Euroblock plug into the Euroblock
connector on the rear panel.
3 mm
approx.7 mm
(5 mm for GPI)
approx.7 mm
(5 mm for GPI)
1.6 mm (1.3 mm for GPI)
or less
Loosen
Slotted Screwdriver
Terminal Screw
Euroblock Plug
DME8i-C/DME8o-C/DME4io-C Owner's Manual
29