Analog Audio Connection ([Input] & [Output] Connectors) - Yamaha DME4io-ES Owner's Manual

Audio I/O Connection
Analog Audio Connection ([INPUT] & [OUTPUT] Connectors)
The DME Satellite can directly input and output audio signals via the [INPUT] and [OUTPUT] connectors.
Wire the supplied Euroblock plugs (3P) as shown below. You can use DME Designer to set the head amplifier
gain and turn the phantom power on and off for each [INPUT] connector.
Cable preparation
Prepare cables to be attached to a Euroblock plug as shown below.
Be sure to use shielded cables.
CAUTION
Do not tin (plate with solder) the exposed sections of the cable.
CAUTION
Euroblock plug connection
NO T E
Use a slotted screwdriver with a blade width of about 3 millimeters to secure the cables to the
(3P) Euroblock plug.
Use a slotted screwdriver with a blade width of about 2 millimeters to secure the cables to the
(16P) Euroblock plug to connect to the [GPI] connector.
1.
Loosen terminal screws.
2.
Insert cables.
3.
Securely tighten terminal screws.
Pull the cables (not too strongly) to confirm that they are securely connected.
4.
Insert the Euroblock plug into the Euroblock
connector on the rear panel.
Shielded Cable
7mm
30mm
Terminal Screw
DME8i-ES/DME8o-ES/DME4io-ES Owner's Manual
3mm
Loosen
Slotted Screwdriver
Euroblock Plug
25