Wolf CT15E/S Design Manual page 35

WOLF WARMING DRAWERS
Planning Information
The warming drawer must be installed with a Wolf drawer
front, avail able through your authorized Wolf dealer. For
local dealer information, visit the find a showroom section
of our website, wolfappliance.com. Specific installation
instructions are included with the drawer front.
The warming drawer platform must be able to support 200
lbs . The platform must be a minimum of 1"
(91 kg)
5
the toe kick to allow for the /
For a standard installation, the drawer collar and front panel
sit proud of the cabinet face frame. A recessed installation
requires the cabinetry be recessed by
is flush with the cabinet face frame but the drawer front
will sit proud. A flush inset installation (excludes L series)
requires the drawer collar and front panel be recessed to be
flush with surrounding cabinetry. Refer to illustrations on the
following pages for minimum cabinet dimensions for your
specific installation.
above
(25)
" trim overlap.
(16)
8
3
/ " so the collar
(5)
16
ELECTRICAL
ELECTRICAL REQUIREMENTS
WARMING DRAWER
Electrical Supply
Service
Receptacle
Power Cord
grounded, 120 VAC, 60 Hz
15 or 20 amp dedicated circuit
3-prong grounding-type
3'
(.9 m)
|
wolfappliance.com 35