Wolf CT15E/S Design Manual page 22

WOLF CONVECTION STEAM OVEN
Planning Information
The convection steam oven can be installed with or without
side trim in a standard or flush inset application. A minimum
base support of 100 lbs
(45 kg)
supply for the oven must be located in an adjacent cabinet.
The oven has face trim on the top and both sides that will
overlap stiles and rails. Refer to the chart below for trim
overlaps with and without side trim. For flush inset installa-
1
/ " reveal is required on all four sides.
tions, a minimum
(3)
8
The Wolf convection steam oven with side trim is designed
and agency approved for installation with Wolf cooktops,
built-in ovens, microwaves and warming drawers only. If
installed above or below an E series oven in a flush inset
1
application, a / " reveal is required.
(6)
4
TRIM OVERLAP
OVERLAP
Top
Bottom
Sides
|
22 Wolf Customer Care 800.222.7820
is required. The electrical
24" OVEN WITH 30" TRIM
3 3
/ " / "
(5) (5)
16 16
0" 0"
(0) (0)
5 13
/ " 3 / "
(16) (97)
8 16
ELECTRICAL
ELECTRICAL REQUIREMENTS
CONVECTION STEAM OVEN
Electrical Supply
Service
Receptacle
Power Cord
grounded, 240/208 VAC, 60 Hz
20 amp dedicated circuit
NEMA 6-20R grounding-type
6'
(1.8 m)