Set-Point Value; Temperature Scale Units - Fluke Hart Scientific 9150 User Manual

200.0 C
S
1. 200.
To change the set-point memory press "UP" or "DOWN".
5. 900.
Press "SET" to accept the new selection and access the set-point value.
S
8.2.2

Set-point Value

The set-point value may be adjusted after selecting the set-point memory and
pressing "SET".
0900.0
The first digit flashes on and off. If the set-point value is correct, press "EXIT"
to display the temperature scale units.
If the first digit is correct press "SET".
To adjust the first digit, press "UP" or "DOWN". Then, press "SET" to go to
the second digit. The second digit of the temperature should now be flashing.
Adjust this digit by pressing "UP" or "DOWN".
Press "SET" to accept the second digit and repeat until the last digit has been
adjusted.
0962.7
Press "SET" to accept the new set-point. If "EXIT" is pressed all changes made
to the set-point are discarded.
S
8.2.3

Temperature Scale Units

Temperature Scale Units of the controller are set by the user to degrees Celsius
(°C) or Fahrenheit (°F). The units are used in displaying the well temperature,
set-point, and proportional band.
Press "SET" after adjusting the set-point value to change display units.
Un= C
Well temperature in degrees Celsius
Access set-point memory
Set-point memory 1, 200.0°C currently used
New set-point memory 5, 900.0°C
Accept selected set-point memory
Set-point value in °C
New set-point value
Accept new set-point value
8 Controller Operation
Temperature Set-point
23