Monster Vision max 3D Owner's Manual page 22

4.4.3 Paired Eyewear Power Operation
When powered on the Eyewear always looks for the last transmitter used, the state of the transmitter
is important for syncing the Eyewear with the transmitter.
Paired – Eyewear Looks for the Last Paired Transmitter
• If the last paired transmitter is inactive, the Eyewear waits for it to become active.
• If the last paired transmitter is active, the Eyewear connects and syncs.
Unpaired – Eyewear Looks for the Last Transmitter Used
• If the last used transmitter is inactive, the Eyewear searches for an active transmitter.
• If the last used transmitter is active, the Eyewear connects and syncs.
4.4.4 Pairing Eyewear and Transmitter
iMPORtANt: Please read through the following steps before proceeding, the operation is
time sensitive.
1. Place the transmitter into pairing mode Pressing & Holding the joystick in any direction until
3 LEDs illuminate GREEN (see section 2.1 Max3D Transmitter Operation on pg. 9).
2. All the LEDs will start a illuminate RED in sequence reminiscent of a heartbeat from all OFF
to slowly increasing in brightness.
3. Within 60 seconds you can pair as many Eyewear units as needed, after 60 seconds repeat
steps 1 and 2 to pair more Eyewear units.
NOtE: IF the joystick is moved within 60 seconds, pairing mode timeout is reset to 0 seconds.
4. Press & hold the power button.
5. After 1 to 2 seconds the LED will illuminate red, continue holding the power button for
10 seconds until the LED pulses in a heartbeat pattern.
6. Release the power button within 10 seconds of the start of the heartbeat pattern.
iMPORtANt: If the power button is not released within 10 seconds the Eyewear defaults
will be restored.
Switching Transmitters
To pair the Eyewear with another transmitter, simply follow the steps for pairing listed above.
To un-pair the Eyewear from a transmitter, follow the steps for resetting factory defaults in section
3.2.4 Restoring Factory Defaults on pg. 13.
20
3.