Monster Vision max 3D Owner's Manual page 20

3. Connect the Micro-USB end
of the included USB cable to
the transmitter.
4. Connect the other end of the USB to a
power source following the guidelines
in section 4.2.1 Max3D Transmitter
Power on pg. 15.
4.3.3.1 Setup for tVs with iR 3D Sync
1. Turn on your 3D TV.
2. Place TV into 3D Mode (refer to TV owner's manual for how to turn 3D on).
3. Hold or place the IR Sensor below the front of the TV near the location of the TVs 3D IR Sync.
4. The transmitter LEDs will display a
transmitter attempts to acquire a 3D signal, this will continue until
it detects a 3D signal.
Should the transmitter not acquire a 3D signal within 60 seconds repeat steps 1 and 2.
Upon finding a 3D signal, all LEDs turn
Weakest Signal
Strongest Signal
Strong Signal
If a strong signal is present you are now ready to enjoy 3D viewing with your Max3D Eyewear...
Monster recommends that the IR sensor be mounted with double sided tape to the TV or cabinet so
that the signal strength can remain strong. Upon first viewing it is advisable to verify the quality of
the 3D image. If the image, when viewed through your MAX 3D Eyewear, is fuzzy, ghosted, or out
of polarity, see section 5.1 Basics of Fine Tuning on pg. 22.
Weak Signal
If a weak signal is present, follow the steps in section 4.3.4 Optimizing IR 3D Sync Signal on pg. 19 until
a strong signal can be found.
18
RED moving pattern while the
GREEN and indicate the IR signal level: