Monster Vision max 3D Owner's Manual page 13

IR Signal Search and Learning
This is used to sync the Transmitter with your 3D TV; each TV has a unique IR code that
allows the transmitter and the TV to communicate. Once a code is synced the transmitter
will look for the same code upon power up. Should you wish to use the eyewear on a
different 3D TV, this mode is used to learn a new IR sync code.
Resetting to Factory Defaults
If the MAX 3D Transmitter is not working properly and other troubleshooting methods have failed,
use Reset to Factory Defaults mode to restore proper operation.
WARNiNG:
• Any settings that were set while in Manual Performance Tuning mode will be erased.
• All pairing information will be removed and pairing to any eyewear will need to be re-established.
1. Press & Hold the Joystick to the left for 10 Seconds
2. All LEDs should illuminate GREEN, Hold until this occurs
3. The factory Reset is complete when all LEDs flash really fast
NOtE: This will only reset the Transmitter, please reset the eyewear as described in section
3.2.3 Resetting Eyewear Transmitter Sync on pg. 13.
11