ACV SmartLine SLME Specification

When to install a Smart Line Multi Energy
Solar applications
Wood/pellet boiler applications
Heat pump applications
HEAT PUMP
POMPE A CHALEUR
8 High efficiency hot water storage
District/centralised
heating applications
SmartLine SLME
Designed for a range of
applications and a multiple
choice of energy sources.
Multi-Energy cylinder with the advantages of Tank-in-
Tank technology and the added benefit of a carbon
steel coil located at the bottom in the primary water.
The large heating surface area and increased primary
volume of the SLME tanks not only increase recovery
time, but also ensure all energy from your renewable
source is absorbed into the tank, reducing fuel bills
and ultimately helping the environment.
Due to the unique design of the Multi-Energy cylinder
and the large primary thermal store, it is the perfect
partner for Solar, Heat Pumps, Pellet Burners, Heat
Recovery Systems, District Heating Applications and
more.
Advantages Over Twin Coil Tank
• Increased heating surface for rapid domestic hot
water recovery
• Large primary volume allows for greater thermal
store
• Can be used as a low loss header for heating circuit
• Smaller compact tank with increased performance
• Immersion heater in primary circuit
• More heat sources absorbed into the tank
• Flexible design options for specifiers and installer
• Extra primary connections for connecting to heating
circuit
1. Polypropylene top lid
2. Polypropylene shell
3. Stainless steel tank (DHW)
4. Polypropylene bottom lid
5. Manual air purge
6. Polyurethane foam insulation
7. Dry well for sensors
8. Outer steel tank (primary
circuits) see diagrams page 9
9. Electric heating element
10. Carbon steel coil
5
1
2
8
8
8
9
7
3
6
10
4