Table of Contents
Advertisement
BIOS Messages
IDE Primary Channel Master Drive Error
IDE Primary Channel Slave Drive Error
IDE Secondary Channel Master Drive Error
IDE Secondary Channel Slave Drive Error
IRQ Setting Error
Expansion ROM Allocation Failed
I/O Resource Conflict(s)
Memory Resource Conflict(s)
System Resource Conflict(s)
PCI Device Error
PS/2 Pointing Device Interface Error
PS/2 Pointing Device Error
PS/2 Pointing Device Error or Not Connected
Onboard Pointing IRQ Device Conflict(s)
Press Ctrl_Alt_Esc key to enter Setup or F1 key to
continue
Press 1 key to enter Setup or other key to continue
Press Esc to turn off NMI, or any key to reboot
Insert system diskette and press <Enter> key to
reboot
52
Action/FRU
Enter BIOS Setup and load the default settings.
Check IDE drive jumper.
IDE hard disk drive power.
IDE hard disk drive cable/connection.
IDE hard disk drive.
Load default settings in Setup.
Enter BIOS Setup and set the Reset Resource
Assignments of the PnP/PCI Options to Yes, then
reboot the system.
Remove all adapter cards that are NOT factory-installed,
then reboot the system
Load default settings in Setup.
Enter BIOS Setup and set the Reset Resource
Assignments of the PnP/PCI Options to Yes, then
reboot the system.
Remove all adapter cards that are NOT factory-installed,
then reboot the system.
Re-connect PS/2 keyboard and mouse.
Enter BIOS Setup and load the default settings.
PS/2 mouse
PS/2 keyboard
System board
Enter BIOS Setup and load the default settings.
Remove all adapter cards that are NOT factory-installed,
then reboot the system.
Press Ctrl-Alt-Del to enter Setup and reconfigure the
system.
Press 1 to enter Setup and check the configuration.
Pressing other keys prevent entering Setup.
Press Esc to reject NMI error or press any other key to
reboot the system.
Insert a bootable disk into the floppy disk drive or remove
this disk if a hard disk is installed.
Chapter 4
Advertisement
Table of Contents
