Setting As Daisy Chain Connection (For The Input Board) - Mitsubishi Electric DLP PH50 series Manual

1.9. Setting as daisy chain connection (for the input board)

The adjustment procedure of a daisy-chained display wall is shown in the following flowchart. Adjust
the first cube, which takes an input signal from an external device, following which, adjust other
downstream cubes that require a digital image signal from the first cube.
Input memory adjustment
Input memory registration
Display memory adjustment
Display memory registration
[Procedure]
1. Adjust and save the input memory and the display memory of the first cube according to "1.7
Input memory setting (for the input board)" on page 57 and "1.8 Display memory setting" on page
66.
2. Select DIGITAL port in other downstream cubes according to "1.7.1 Input port selecting" on page
57.
3. Adjust and save the input memory and the display memory of the downstream cubes in the same
way as the first cube. Normally it is unnecessary to change the input signal position. It is
automatically set in automatic input signal scanning (chapter 1.7.3, on page 57). Make certain
that same images are displayed on each screen as the following example.
Start
in the first cube
in the first cube
in the first cube
in the first cube
Daisy-chained display wall adjustment flowchart
Image signal
A
A
Digital input selecting and input memory
adjustment in downstream cubes
Input memory registration
in downstream cubes
Display memory adjustment
in downstream cubes
Display memory registration
in downstream cubes
A
A
69
End
REV 2.4