4.7. Menu bar
4.7.1. File menu
4.7.1.1. Save System Config...
Used to save the current software configuration in a designated file. Name an arbitrary file name.
It creates a file with .cfg extension that contains following items.
•
Serial port number
•
Communication speed
•
Display wall configuration
•
Panel ID numbers
4.7.1.2. Open System Config...
Used to configure the software according to the data saved in "Save System Config..." menu.
4.7.1.3. Save Parameter
Used to read all current memories in the software in selected panels to save in a file. Name an
arbitrary file name. It creates a file with .wpd extension.
4.7.1.4. Open Parameter
Used to send the file data saved in "Save Parameter" menu to selected cubes. You can choose
following options.
•
Only Input Parameter
•
Only Display Parameter
•
Only Service Parameter
•
All Parameter
4.7.1.5. Read & Save memory
Used to read all memory data in selected cubes to save in a designated folder (chapter 4.5.1, on
page 112). Name an arbitrary folder name. It creates files with .bku extension in the folder.
4.7.1.6. Open & Send memory
Used to send back the file data saved in "Read & Save memory" menu to cubes (chapter 4.5.2,
on page 112).
4.7.1.7. Exit
Used to quit the software.
PH50, XL50, XL21 series Set-up and Installation Manual
: Sending only input memory data
: Sending only display memory data
: Sending only system memory data
: Sending all above memory data
114