Table of Contents
Advertisement
3.
For horizontal adjustment:
horizontal position and fix them.
its horizontal position and fix it. The screen guide has punch marks at the adjustable range
(+/- 2mm) and its center.
4.
For vertical adjustment: Loosen two screws each in the left and right screen guides to adjust
their vertical positions and fix them.
same position as described above.
5.
Close the screen units (chapter 1.2.7.2, on page 22).
6.
Check the screen gaps and repeat the steps until you get reasonable gaps.
For vertical
adjustment
5
0
"
Left screen guide
5
0
"
1.2.6.6. Fixing to the wall and floor
1.
Attach floor-fixing brackets on 4 level adjusters below the base stand and fix them to the
floor with anchor bolts.
2.
Fix the upper back part of the display wall to the back wall with wall-fixing brackets as shown
in the following figure.
Caution
Make sure the whole set is assembled firmly and installed stably. To prevent the set from falling
due to unpredictable events such as earthquakes and shocks, fix the set firmly to the wall and
floor. Furthermore, carefully confirm the strength of the fixing area of the installation place (wall
and floor). The wall and floor fixing method differs according to the number of the assembled units.
PH50, XL50, XL21 series Set-up and Installation Manual
5
0
"
: Loosen two screws in the right screen guide to adjust its
5
0
"
6
6
7
7
"
"
: Loosen the screw in the bottom screen guide to adjust
6
6
7
7
"
"
: The screen guides have the punch marks at the
For horizontal
adjustment
6
7
"
Bottom screen guide
6
7
"
Hexagon socket head
cap screws (M6)
Adjusters
20
For vertical
adjustment
For horizontal
adjustment
5
5
0
0
"
"
Right screen guide
For vertical
adjustment
6
6
7
7
"
"
Screen guide (both side)
Wall-fixing brackets
Anchor bolts
Anchor bolts
Floor-fixing brackets
Hide quick links:
Advertisement
Table of Contents
