Attaching The Hdd To The Hdd Tray; When Attaching One Hdd - Mitsubishi Electric DX-NT430E Installation And Operation Manual

Hide thumbs Also See for DX-NT430E:

Table of Contents

Attaching and removing the HDD (continued)

Attaching the HDD to the HDD tray

1. Remove the top cover from the HDD tray.

• Remove the 2 screws and lift the top cover.

2. Remove the HDD holder on the right side of the HDD tray.

• Remove the 4 screws attached to the HDD holder to remove

the HDD holder.

3. Attach the HDD holder on the side of the HDD.

• Use the 4 supplied screws to attach the HDD holder.

• Set the jumper of the HDD to "MASTER." Refer to the

instruction book of HDD for setting the jumper.

4. Attach the HDD holder to the HDD tray.

• Use the 4 screws that were removed in step 2.

•••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••

5. Connect the middle connector of the ATA LEAD to the HDD.

• Make sure that the lead between the PCB and the HDD is

clamped. (A)

6. Unclamp the POWER LEAD and connect to the HDD.

• Clamp the POWER LEAD again after connecting to the HDD.

(B)

7. Check the wiring.

A: The lead between the PCB and the HDD is clamped.

B: The POWER LEAD which is connected to the HDD is

clamped.

C: The POWER LEAD and the ATA LEAD that are not

connected are clamped near their ends.

D: Push the POWER LEAD and the ATA LEAD between the

middle connector and the outer connector into the space

between the PCB and the HDD.

B, C

Table of Contents