Table of Contents
Advertisement
20
See
Inset
Front Axle
Bottom View
• Turn the vehicle body over so that the bottom faces you.
• Insert one #8 x
/
" screw through the front hole in the
3
4
vehicle body and into the windshield, as shown.
• Fit a small washer to two #8 x
screws with washers through the other holes in the vehicle
body and into the windshield, as shown.
• Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
Assembly
See
Inset
3
/
" screws. Insert these
4
21
Front
Axle
• Turn the steering linkage so that
the inside (grooved side) is
facing up and the curve is
toward you.
• Position each front axle so that
the short end is facing up.
• Insert the short end of the front
axles up through the ends of
the steering linkage, as shown.
22
B Marking
Large
Washer
Front
Axle
Steering
Linkage
Cover
B Marking
TOWARD
• Slide a large washer onto the
short end of each front axle.
• Position the steering linkage
cover over the steering linkage.
Make sure the A and B
markings in the steering linkage
cover match the A and B
markings in the steering linkage. Fit the steering linkage
cover onto the front axles.
16
Note: The steering linkage curve should still face you.
Steering Linkage
Steering Linkage
Curve TOWARD You
A Marking
See
Inset
Steering
Linkage
Curve
You
Front
Axle
See
Inset
Steering
Linkage
Short End of
Front Axle
Long End of
Front Axle
Large
Washer
Front
Axle
A Marking
Steering
Linkage
Cover
Large
Washer
A Marking
Advertisement
Table of Contents
