Table of Contents
Advertisement
F
WARNING
Children can be harmed by small parts,
sharp edges and sharp points in the
vehicle's unassembled state, or by electrical
items. Care should be taken in unpacking
and assembly of the vehicle. Children
should not handle parts, including the
battery, or help in assembly of the vehicle.
1
Rear Axle
See
Inset
Bottom View
• Turn the vehicle body
over so the bottom is
facing you.
• Loosen and remove the screw and washer holding the rear
axle in place. Remove the rear axle. Set the rear axle aside
for assembly step 4.
• Throw away the screw and washer. They are not
needed for assembly.
Assembly
Screw and Washer
Screw
Rear
Washer
Axle
2
Plastic
Retainer
Rear View
• Turn the vehicle body upright.
• Using safety scissors, cut the
plastic retainer holding the gearbox in place.
• Throw away the plastic retainer.
3
Gearbox
Barrel Side
Round Bushing
• Fit a round bushing, barrel side first,
into the hole inside the battery
compartment.
• Position the gearbox with the teeth
outward. Fit the gearbox through the
11
large opening in the side of the battery compartment.
See
Inset
Cut and Remove
Plastic Retainer
Hole
See
Inset
Hole
Rear View
Gearbox
Teeth
Large
Opening
Round
Bushing
Round
Bushing
Advertisement
Table of Contents
