• Fit the assembly tool (with lock washer in it) onto the end of
the rear axle.
• Tap the assembly tool with a hammer to secure the lock
washer on the end of the rear axle.
• Pull the wheel up to be sure it is secure on the rear axle.
Notches
12
Wheel
Ridges
• Fit the notches on the inside of a traction band to the ridges
on a wheel, as shown.
Hint: Soak the traction band in hot water for about two
minutes to soften it.
13
• Slide the other side of the traction band around the wheel.
Assembly
Notches
Traction
Band
Ridges
Traction Band
14
14
Slots
Tab
Tab
Tab
• Insert one of the tabs on the hubcap cover into a slot in
the hubcap.
• Then, push with your fingernail (or carefully with a
slotted screwdriver), the other two hubcap cover tabs into
the slots in the hubcap.
• Repeat this procedure to assemble another hubcap cover
to the other hubcap.
15
• Insert eight #8 x
/
" screws into the door, as shown.
3
4
• Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
Hubcap
Hubcap
Cover
See
Inset
• Turn the vehicle body
upright (or keep on its side).
Door