Table of Contents
Advertisement
LINE CONNECTION
Use the telephone cable supplied with the facsimile expansion kit to connect the machine to a telephone line.
Connect the cable so that the connector nearest to the noise
suppression core is inserted into the socket located of the
expansion kit box. Insert the other end into the telephone line
socket.
In some countries, an adapter is required to connect the
telephone line cable to the wall telephone socket, as shown in
the illustration.
POINTS TO CHECK AND PROGRAMMING AFTER INSTALLATION
After installing the unit and before using it as a fax machine, check the following points and program the required
information.
Make sure the fax power switch is turned on
In addition to the main power switch, the rear of the unit also has a power switch for fax functionality. If this power
switch is not turned on, you will not be able to use the unit as a fax machine. Please keep the fax power switch
turned on at all times.
Make sure the correct date and time have been set
Make sure the correct date and time have been programmed in the unit (refer to page 3-8 of "Operation manual
(for printer operation and general information)"). If the date and time are wrong, please correct them.
It is important to set the correct date and time because they are used for such features as Timer Transmission
(page 3-6).
Program the sender's name and sender's number
Refer to page 8-4 to program the name and fax number of the user of this product using the key operator program.
The programmed name and number are printed at the top of each transmitted fax page. The sender's number is
also used as an identification number when you use the Polling function to request transmission from another fax
machine (refer to page 3-6).
NOTE
You can check your programmed name and number by printing out the Sender List. (Refer to page 8-10.)
1-2
Line connector
Core
Wall socket
For United
Kingdom
For Australia
For New Zealand
TE L
LI NE
Adapter
Advertisement
Table of Contents
