Watching Video Images And Laser Disc Images - Sharp XG-V10WE Operation Manual

Watching Video Images and Laser Disc Images

Connecting to a VCR, laser disc player and other audiovisual equipment using
the BNC video Input
1 1
S-video cable (sold separately)
CAUTION
• Always turn off the projector before connecting to video equipment, in order to protect both the projector and the equipment
being connected.
17
1 Connect each BNC connector of a component or video cable to the
corresponding BNC INPUT 4 or 5 terminals on the projector.
• BNC-RCA adaptors are needed for use with RCA type cables and sources.
2 Connect the other end of the cable to the corresponding terminals on a VCR
or laser disc player.
3 To use the built-in audio system, connect one end of an audio cable (sold
separately) to AUDIO INPUT 4 or 5 terminal on the projector.
4 Connect the other end to the audio output terminal on the video component.
The S-VIDEO INPUT terminal uses a video signal system in which the picture is
separated into a colour and a luminance signal to realise a higher-quality image.
When cables are connected to both the S-VIDEO INPUT 4 or 5 and VIDEO INPUT
4 or 5 terminals, images input through the S-VIDEO INPUT 4 or 5 terminal have
priority over images input through the VIDEO INPUT 4 or 5 terminal.
• For higher quality video, you may use the S-VIDEO INPUT terminal on the projector. S-
video cable is sold separately.
• If your video equipment does not have an S-video output terminal, use a composite video
cable.
Three BNC-RCA adaptors
(Sold separately)
Video cable (sold separately)
or
Component cable (sold separately)
3
Audio cable
(sold separately)
2 To video
output terminals
2 To analog component
output terminals
4 To audio
output terminals
To S-video output terminal
VCR
or
Laser disc player