Table of Contents
Advertisement
F
Notches
Wheel
Ridges
29
• Fit the notches on the inside of a front wheel traction band to the
ridges on a front wheel, as shown.
Hint: Soak the traction band in hot water for about two minutes to
soften it.
30
• Slide the other side of the front wheel traction band around the
front wheel.
18
ASSEMBLY
Notches
Front Wheel
Traction Band
31
Slots
Ridges
• Turn the vehicle upright (or keep it on its side).
• Insert one of the tabs on the hubcap cover into a slot in the hubcap.
• Then, push with your fingernail (or carefully with a slotted screwdriver),
the other two hubcap cover tabs into the slots in the hubcap.
• Repeat assembly steps 27 - 31 to assemble the remaining wheel
(with round bushing and hex bushing) lock washer, front wheel
traction band, hubcap and hubcap cover.
32
• Place the steering wheel top face down on a flat surface.
• Fit the steering wheel bottom to the steering wheel top.
• Insert five #6 x
into the steering wheel top. Tighten the screws.
Hubcap
Tab
Tab
Steering
Wheel
Top
1
/
" screws through the steering wheel bottom and
2
Hubcap
Cover
Tab
Steering
Wheel
Bottom
L1114pr-0920
Advertisement
Table of Contents
