Fisher-Price Volkswagen NEW BEETLE L1114 Owner's Manual & Assembly Instructions page 16

F
B Marking
Large
Washer
Front
Axle
Steering
Linkage
Cover
B Marking
Steering
Linkage Curve
TOWARD You
20
• Slide a 5 / " large washer onto the
16
short end of each front axle.
• Position the steering linkage cover
over the steering linkage. Make sure
the A and B markings in the steering
linkage cover match the A and B
markings in the steering linkage. Fit
the steering linkage cover onto the front axles.
Note: The steering linkage curve should still face you.
21
• Fit a .437 white cap nut onto the end of a front axle.
• Tap the cap nut with a hammer to secure it to the front axle.
• Repeat this procedure to fasten another .437 white cap nut to the
other front axle.
16
ASSEMBLY
A Marking
Large
Washer
Front
Axle
A Marking
22
• Turn the steering assembly
over, with the smooth side up.
• Fit the steering linkage
assembly to the front end of
the vehicle.
IMPORTANT! Make sure the notch on the steering linkage assembly
aligns with the notch in the front end of the vehicle.
Cap
Nut
Front
Axle
23
.437"
• Insert two
linkage assembly and into the vehicle.Tighten the screws.
• Pull up on the steering linkage assembly to be sure it is secure. If it is
not secure, tighten each screw a few more turns.
Steering Linkage
Assembly
(Smooth Side Up)
Deep
Holes
1 / " x 1 1 / " screws through the deep holes in the steering
4 4
Notch Notch Notch
Notch
Steering
Linkage
L1114pr-0920