Fisher-Price Volkswagen NEW BEETLE L1114 Owner's Manual & Assembly Instructions page 15

Fold around
back edge of
windshield
Dotted Line
Label 11
16
• Position the windshield upright, as shown.
• Remove the backing and position label #11 on the right side of the
windshield, as shown.
Hint: Align the dotted line on the label with the back edge of
the windshield.
• Fold the back end of the label around the back edge of
the windshield.
Tabs Tabs Tabs
IMPORTANT!
Insert side tab into
this slot FIRST
17
• Note the location of six tabs and one peg on the windshield.
• First insert the tab on the side of the windshield (that is opposite the
door) into the slot in the vehicle.
• Then fit the remaining five tabs and peg on the windshield into the
slots and hole in the vehicle.
• When you are sure all six tabs and one peg are inserted, push
down on the windshield to snap the tabs in place.
L1114pr-0920
ASSEMBLY
Back Edge
of Windshield
Windshield
Tabs Tabs Tabs
Peg
BOTTOM VIEW
18
Front
Hole
• Turn the vehicle over so that the bottom faces you.
• Insert one #8 x 3 / " screw through the front hole in the vehicle and
4
into the windshield, as shown.
• Fit a ¼" small washer to two #8 x
with washers through the other holes in the vehicle and into the
windshield, as shown.
• Tighten the screws.
Steering Linkage
Front
Steering Linkage
Axle
Curve TOWARD You
19
• Turn the steering linkage so that
the inside (grooved side) is facing
up and the curve is toward you.
• Position each front axle so that the
short end is facing up.
• Insert the short end of the front
axles up through the ends of the
steering linkage, as shown.
3 / " screws. Insert these screws
4
Front
Axle
Steering
Linkage
Short End of
Front Axle
F
15