Page 3
Elevator Base • Insert the tabs on the bottom of the elevator into the slots in the base. • Push to "snap" in place. Pump • Insert the tabs on the pump into the slots in the base. • Push to "snap"...
Page 4
Center Floor • Fit the center floor onto the two columns, as shown. • Press down on the center floor near the elevator and each column to "snap" in place. Top Floor Floor Support Posts • Fit the floor support onto the posts on the underside of the top floor.
Page 5
Ramps • Insert the the tabs on one ramp into the slots in another ramp. • Repeat this procedure with the remaining ramps to create another ramp assembly. • Insert and "snap" the tab on one of the ramp assemblies into the slots in the base.
Assembly BOTTOM VIEW • Turn the assembly over. • Insert a screw through the hole in the center floor and into the ramp assembly. Tighten the screw. Handle • Turn the assembly upright. • Fit the handle onto the elevator and post. •...
Page 7
Three Stories of Fun! Lift the elevator to the top floor. Press for fun sounds. Send the car spinning down the ramp. Spin the air hose.
Need help?
Do you have a question about the L1343 and is the answer not in the manual?
Questions and answers