Confirmation After Installation - Roland SuperNATURAL BRASS ARX-03 Owner's Manual

Confirmation after Installation

After you've finished installing the expansion board, you will need
to perform the following procedure to confirm the installation.
This installation procedure needs to be performed only the first time
you power up your device after installing the expansion board.
1. Power up your device as described in its owner's
manual.
2. If the expansion board was installed correctly, an
installation confirmation screen will appear.
Press the [F8] (Execute) button to begin installation.
* The screen shown here is for when the board is installed in the
Fantom-G.
If the installation confirmation screen does not appear the first
time you power up after installing the expansion board, it is
likely that the board was not installed correctly. Check once
again to make sure that the board is correctly installed.
It may take one to five minutes before installation is finished.
Never turn off the power during this installation process.
3. When you see the Power Off screen indicating that
installation is finished, switch your device's "Please
Power Off!", then on again as described in its owner's
manual.
This completes the expansion board installation process.
11