SATO CL408 Programming Manual page 153

Programming Manual
Note:
1. If any of the parameters entered are outside the valid range, a
symbol will not be printed when the <ESC>DC Print Data com-
mand is sent to the printer.
2. The number of cells per line (eee) and the number of cell lines (fff)
should be specified as all zeroes, allowing the printer to automat-
ically calculate the optimum configuration for the symbol.
3. The Reference Point for the Data Matrix symbol is the upper-left
corner. If an <ESC>R Rotate command is used to rotate the sym-
bol, it will rotate in the counter-clockwise direction.
4. The Format ID specified for "aa" is defined by the following table.
The printer only supports the Format ID's defined in the table.
ID
Number
01
02
03
04
05
06
11
12
13
14
15
16
5. The maximum number of data characters that can be specified for
either the 16-Bit or 32-Bit CRC modes is 500.
SATO RISC Printers
CHARACTER SET
16 Bit CRC
Numeric, Space
Upper Case Alpha, Space
Upper Case Alpha, Space,Comma,
Period, Slash, Minus
Upper Case Alphanumeric, Space
ASCII 7-bit, Full Keyboard (20H -7FH)
ISO 8-bit, International (20H -FFH)
32 Bit CRC
Numeric, Space
Upper Case Alpha, Space
Upper Case Alpha, Space, Comma,
Period, Slash, Minus
Upper Case Alphanumeric, Space
ASCII 7-bit, Full Keyboard (20H -7FH)
ISO 8-bit, International (20H -FFH)
4. Bar Code Specifications
ENCODING
SCHEME
Base 11
Base 27
Base 41
Base 37
ASCII
8-Bit
Base 11
Base 27
Base 41
Base 37
ASCII
8-Bit
153