Connecting Wires To Terminals - Kenwood DPX-U6120 Instruction Manual

Connecting Wires to Terminals

Fuse (10A)
Wiring harness
(Accessory 1)
Blue/White (Power control wire)
Blue (Antenna control wire)
Brown (Mute control wire)
Orange/ White (Dimmer control wire)
Light Blue/ Yellow (Steering
remote control wire)
Red (Ignition wire)
Yellow (Battery wire)
Black (Ground wire) · (To car chassis)
FM/AM antenna input (JASO)
Front output (DPX-U6120/ DPX-U5120 only)
Rear output/ Sub Woofer output
To Kenwood disc changer/External optional accessory
(DPX-U6120 only)
To connect these leads, refer to the relevant instruction
⁄
manuals.
White
White/Black
Gray
Gray/Black
Green
Green/Black
Purple
Purple/Black
If no connections are made, do not let the wire come out from the tab.
P.CONT
ANT.
CONT
MUTE
ILLUMI
REMOTE CONT
STEERING WHEEL
REMOTE INPUT
Antenna Cord
To front left speaker
To front right speaker
To rear left speaker
To rear right speaker
When using the optional power amplifier, connect to its power
control terminal.
Depending on what antenna you are using, connect either to
the control terminal of the motor antenna, or to the power
terminal for the booster amplifier of the film-type or short pole
type antenna.
Connect to the terminal that is grounded when either the
telephone rings or during conversation.
To connect the Kenwood navigation system, consult your
⁄
navigation manual.
To car light control switch
To use the steering wheel remote control feature, an exclusive
remote adapter (not supplied) that matches your car is required.
Ignition key
switch
ACC
Car fuse
box
Car fuse box
(Main fuse)
– +
Battery
53
|
English